When you are faced with the following errors, such as it is presented when resolving this issue “Error code 0x204: We could not connect to the remote PC, make sure the PC is turned on and connected to the network, and that the remote access is enabled“. The below error messages will be prompted and without a good understanding of this, you may never be able to resolve this. Because of this, I have decided to discuss these details.
PS C:\administrador> ping 192.168.178.5 -t Pinging 192.168.178.5 with 32 bytes of data: Request timed out. Request timed out. Reply from 192.168.178.5: Destination host unreachable. Reply from 192.168.178.5: Destination host unreachable. Request timed out. Reply from 192.168.178.5: Destination host unreachable. Reply from 192.168.178.5: Destination host unreachable. Reply from 192.168.178.5: Destination host unreachable. Request timed out. Reply from 192.168.178.5: Destination host unreachable.
Destination Host Unreachable: This message indicates one of two problems: either the local system has no route to the desired destination or a remote router reports that it has no route to the destination.
– If the message is simply “Destination Host Unreachable,” then there is no route from the local system, and the packets to be sent were never put on the wire.
Request Timed Out: This message indicates that no Echo Reply messages were received within the default time of 1 second. This can be due to many different causes; the most common include network congestion, failure of the ARP request, packet filtering, routing error, or a silent discard.
– Request timed out means that the local host did not receive a response from the destination host, but it was able to reach it. Destination host unreachable means that there was no valid route to the requested host.
Ping: Transit Failed, General Failure: This error indicates many issues such as not having the ethernet cable plugged in, Network card related issues. It could also be driver related issues with the NIC, or the NIC has been disabled.
PS C:\administrador> ping 192.168.178.5 -t PING: transmit failed. General failure. PING: transmit failed. General failure.
Note: You may have to reset the Device TCP/IP Address and if the issue is cable related, then this alone will not resolve it. I advice, take a look at this article for tips to resolve this issue.
Also When prompted with the Ping: Transit Failed and General Failure error, and the above-mentioned errors do not apply to you. Simply have the DNS flushed. For more information, see DNS Error: How to fix Err Connection Timed Out Error.
I hope you found this blog post helpful. If you have any questions, please let me know in the comment session.